U3302 BMW Fault Code

Description:

The input turbine speed sensor detects rotation of the input shaft of the input shaft speed sensor transmission. The computer uses that information, along with the output shaft speed sensor to determine if the transmission is operating according to plan. If the computer detects a difference between the input shaft speed , and the expected output shaft speed, it will adjust transmission pump pressure to prevent clutch disc slip. If adding pressure doesn't solve the problem, it will set a trouble code.

U3302 Code Symptoms :

The original multi-displacement system turned off opposite pairs of cylinders, allowing the engine to have three different configurations and displacements. U3302 code had an elaborate diagnostics procedure, including showing engine trouble codes on the air conditionning display. However, the system was troublesome, misunderstood by customers, and a rash of unpredictable failures led to the technology being quickly retired.

Diagnosis And Repairing U3302

U3302 OBD2 reports a sensor fault, replacement of the sensor is unlikely to resolve the underlying problem. The fault is most likely to be caused by the systems that the sensor is monitoring, but might even be caused by the wiring to the sensor itself.

How to fix U3302 code ?

• Damaged VCT phaser
• Dirty Oil
• Incorrect fuel filler cap used
• Faulty Crankshaft Position Sensor (POS)

At this point we are assuming that the fuses and relays are good. You will need to locate the PCM/TCM and the power input signal circuit using your vehicle information source.

Unplug the connector from the PCM/TCM, place the ignition switch in the ON position, and probe the appropriate circuit with the positive test lead of the DVOM.